PSC 4ECO 250T ECR ROOF - Insulating Protective Paint for Metal Roofs - 18 Litres Bucket

PSC 4ECO 250T ECR ROOF  is a highly efficient non-toxic, environmentally friendly, energy-saving and flexible insulation paint for insulating and sealing new and old metal roofs and roof structures. It is also suitable for clay and concrete tiles on roofs with a slope of more than 3%. It can also be used to paint ventilation ducts, pipes and downpipes, gutters made of hard PVC and galvanised sheet metal. PSC 4ECO 250T ECR ROOF  paint is an effective protection against frost penetration and surface condensation of water vapour. The paint coating is stable and has high adhesion to metals without surface corrosion. It has thermo-reflective properties and increased adhesion to the substrate and covers micro cracks with just one coat. This paint has excellent resistance to corrosion, condensation and C4 and C5 chemical environments. Supplied in plastic buckets of 18 litres.

Consumption per 1 m2 (one coat on all suitable surfaces with a perfectly flat surface)

• At a thickness of 0.15 mm: 0.18 litres/1m2
  
• At a thickness of 0.20 mm: 0.24 litres/1m2
• At a thickness of 0.24 mm: 0.30 litres/1 m2

CHARACTERISTICS

• A water-based insulating paint based on acrylic resin,
• Highly efficient insulation paint for metal roofs and roof structures,
• Increased adhesion to metal surfaces,
• Able to cover micro cracks with just one coat,
• Non-toxic and environmentally friendly,
• Fully washable and resistant to dirt and chemicals,
• Saves energy,
• Excellent resistance to corrosion and condensation,
• It can be dyed with any colour.

APPLICATION

• Intended for painting metal roofs and roof structures,
• Also suitable for clay and concrete tiles on roofs with a slope of more than 3%.

INSTALLATION

• All surfaces must be clean and free from dirt (dust, dirt, oil and grease) and free from rust,
• A wire brush, sandpaper or sandblasting is recommended to clean the metal,
• Roofs should be washed with water under pressure or sandblasted,
• Remove old coatings and any unstable elements,
• In case of fungus, use appropriate fungicide preparations,
• Can be diluted with water before use,
• The amount of water used for dilution should not exceed 0.3l per 18 litre bucket,
• Mix with a mechanical mixer at low speed (up to 150 rpm) for 3-5 minutes and for 5-7 minutes with manual mixing,
• Do not apply the product in the rain,
• The temperature of the surroundings and the painted surface should be between +5 and +30 Centigrade,
• Relative air humidity should be below 80%.