PSC 4ECO 250T ECE ELASTIC - Insulating Protective Paint for Plastic and Metal Surfaces - 18 Litres Bucket

PSC 4ECO 250T ECE ELASTIC is a highly efficient non-toxic, environmentally friendly, energy-saving and flexible insulation paint for insulating and sealing plastic and metal surfaces. It has thermo-reflective properties and increased adhesion to the substrate and covers micro cracks with just one coat. PSC 4ECO 250T ECE ELASTIC is a water-based insulating paint based on acrylic resin filled with microspheres. Microspheres are small spherical particles with surface modification for specialised applications. PSC 4ECO 250T ECE ELASTIC insulating paint is fully washable and resistant to dirt and chemicals and C4 and C5 chemical environments. The painted surface has excellent resistance to biological corrosion and condensation. This paint can be used to paint ventilation and downpipes, as well as gutters made of hard PVC and galvanised sheet metal. Supplied in plastic buckets of 18 litres.

Consumption per 1 m2 (one coat on all suitable surfaces with a perfectly flat surface)

• At a thickness of 0.15 mm: 0.18 litres/1m2
  
• At a thickness of 0.20 mm: 0.24 litres/1m2
• At a thickness of 0.30 mm: 0.30 litres/1 m2

CHARACTERISTICS

• A water-based insulating paint based on acrylic resin,
• Highly efficient insulation paint for plastic and metal surfaces,
• Has thermo-reflective properties,
• Increased adhesion to the substrate,
• Able to cover micro cracks with just one coat,
• Non-toxic and environmentally friendly,
• Fully washable and resistant to dirt and diluted chemicals,
• Saves energy,
• Excellent resistance to corrosion and condensation,
• Excellent resistance C4 and C5 chemical environments,
• It can be dyed with any colour.

APPLICATION

• Intended for painting rigid and flexible plastic surfaces (PVC, PS, PC, etc.),
• Can be used to paint new and old metal roof surfaces,
• To paint ventilation openings, downpipes, gutters made of hard PVC and galvanised sheet metal.

INSTALLATION

• All surfaces must be clean and free from dirt (dust, dirt, oil and grease) and free from rust,
• A wire brush, sandpaper or sandblasting is recommended to clean the metal,
• Roofs should be washed with water under pressure or sandblasted,
• Remove old coatings and any unstable elements,
• In case of fungus, use appropriate fungicide preparations,
• Can be diluted with water before use,
• The amount of water used for dilution should not exceed 0.3l per 18 litre bucket,
• Mix with a mechanical mixer at low speed (up to 150 rpm) for 3-5 minutes and for 5-7 minutes with manual mixing,
• Do not apply the product in the rain,
• The temperature of the surroundings and the painted surface should be between +5 and +30 Centigrade,
• Relative air humidity should be below 80%.