PSC 4ECO 250T ECBB BASIC B- Insulating Primer for Plastered Surfaces - 18 Litres Can

PSC 4ECO 250T ECBB BASIC B is a highly efficient non-toxic, environmentally friendly, energy-saving and flexible insulation primer for insulating and sealing plastered surfaces. PSC 4ECO 250T BASIC primer can be used on gypsum boards, plasterboards, gypsum, cement and cement-lime plasters, concrete substrates, aerated concrete, ceramics. This primer increases the adhesion of paints to the substrate and consolidates substrates with an uneven structure. Supplied in plastic cans of 18 litres. Colour white.

Note: Cannot be used on PE, HDPE, PP, PTFE and other plastics.

Consumption per 1 m2 (one coat on all suitable surfaces with a perfectly flat surface)

• At a thickness of 0.10 mm: 0.12 litres/1m2
  
• At a thickness of 0.15 mm: 0.18 litres/1m2
• At a thickness of 0.20 mm: 0.24 litres/1 m2

CHARACTERISTICS

• Non-toxic and environmentally friendly primer,
• Highly efficient insulation primer for plastered surfaces,
• Increased adhesion to plastered surfaces,
• Can be used on on all absorbent and porous surfaces,
• Resistant to dirt and chemicals,
• Increases the adhesion of paints to the substrate and consolidates substrates with an uneven structure,
• Comes in white colour.

APPLICATION

• Intended as a primer for gypsum boards, plasterboards, gypsum, cement and cement-lime plasters, concrete substrates, aerated concrete, ceramics,
• On porous surfaces.

INSTALLATION

• All surfaces must be clean and free from dirt (dust, dirt, oil and grease) and free from rust,
• Remove old coatings and any unstable elements,
• In case of fungus, use appropriate fungicide preparations,
• Can be diluted with water before use,
• The amount of water used for dilution should not exceed 0.2l per 18 litre bucket,
• Mix with a mechanical mixer at low speed (up to 150 rpm) for 3-5 minutes and for 5-7 minutes with manual mixing,
• Do not apply the product in the rain,
• The temperature of the surroundings and the painted surface should be between +5 and +25 Centigrade,
• Relative air humidity should be below 80%.