15mm British Gypsum Gyproc Moisture Resistant Plasterboard
15mm British Gypsum Gyproc Moisture Resistant Plasterboard
Price: £22.74 (£27.29 inc VAT)
Price per m2: £7.90/m2 (£9.48 inc VAT)
- Product Code: A1-1361
- Delivery Time: 2 - 3 working days
- Brand: British Gypsum (Tech. support: 01159456123)
- Model and Size: 2400x1200mm - 2.88m2
Our ratings on 22-12-2024:
4.7 out of 5 - Excellent
4.8 out of 5
15mm British Gypsum Gyproc Moisture Resistant Plasterboard
Width: 1200mm
Length: 2400mm
Board Coverage: 2.88m2
Weight/m2: 10.1kg
Thermal Conductivity: 0.190W/mK
15mm Gyproc Moisture Resistant (MR) Board is a Gypsum plasterboard with water repellent additives in the core and paper liners that consists of an aerated gypsum core with glass fibre, water repellent and other additives encased in and firmly bonded to strong paper liners. It is a plasterboard that is suitable for drylining internal surfaces. This plasterboard is certified to BES 6001 achieving a rating of ‘Very Good’.
Plasterboard linings provide good fire protection owing to the unique behaviour of the non-combustible gypsum core when subjected to high temperatures. This plasterboard is designated as a material of limited combustibility and the plasterboard surfaces are designated Class 0 for the purposes of National Building Regulations.
APPLICATION
Gyproc MR Board is used as the main board to provide fire protection with temporary moisture protection during construction.
INSTALLATION
It is important to observe appropriate health and safety legislation when working on site i.e. personal protective clothing and equipment etc. Manual off-loading of this product should be carried out with care to avoid unnecessary strain. Gyproc MR Board may be cut using a plasterboard saw or by scoring with a sharp knife and snapping the board over a straight edge. Holes for switch or socket boxes should be cut out before the boards are fixed using a utility saw or sharp knife.
Fix boards with decorative side out to receive joint treatment or a skim plaster finish. Lightly butt boards together. Never force boards into position. Install fixings not closer than 13mm from cut edges and 10mm from bound edges. Position cut edges to internal angles whenever possible, removing paper burrs with fine sandpaper. Stagger horizontal and vertical board joints between layers by a minimum of 600mm. Locate boards to the centre line of framing where this supports board edges or ends.
PRECAUTIONS
Plasterboard is unsuitable for use in areas subject to continuously damp or humid conditions and must not be used to isolate dampness. They are not suitable for use in temperatures above 49°C but can be subjected to freezing conditions without risk of damage. The thermal insulation and ventilation requirements of national Building Regulations aim to reduce the risk of condensation and mould growth in new buildings. However, designers should take care to eliminate all possibility of problems caused by condensation, particularly in refurbishment projects.
CERTIFICATIONS
BS 476: Part 6: 1989 Method of test for fire propagation for products. Index of performance not exceeding 12 and not exceeding 6.
BS 476: Part 7: 1997 Surface spread of flame tests for materials. Class 1 (both sides).
EN 520: 2004, A1:2009. Classified without further testing as A2-s1, d0